John Deere 102-122 hydro Workshop Manual (TMlr175)

TABLE OF CONTENTS

Drive pedal adjustment ( > Hydrostatic drive models)
Aligning the cutting deck
Steering allowance adjustment
Steering geometry adjustment
Checking blades alignment
Removing, sharpening and balancing the blades
Removal of front hood
Removal of the wheel cover (TC
Removal of the wheel cover (TX-TS)
Removal of the collector channel
Removal of the dashboard (TC
Removal of the dashboard and front cover (TX-TS)
Removal of the engine
Removal of the rear axle (Peerless MST 205-554 – Dana 4360-196)
Removal of the rear axle (Tuff Torq K46F)
Removal of the cutting deck
Replacement of tyres and wheels
Replacement of front wheel bearings
Dismantling of the steering components
Of drive
Replacement of the small wheels for the drive belt
Replacement of the blades control belt
Replacement of the blades connection belt
Replacement of the blades engagement cable ( For lever operated engagement models)
Replacement of the supports and shafts of the blades
Replacement of the accelerator
Replacement of the brake pads and disc ( > Mechanical drive models)

Guide to the identification of problems in the electrical system (TC …)
Guide to the identification of problems in the electrical system (TX-TS)
Summary table for the cutting in of the safety devices (TC
Summary table for the cutting in of the safety devices (TX-TS)
Safety microswitches and switches operation check (TC …)
Safety microswitches and switches operation check (TX-TS)
Terminal board supply check (TC
Terminal board supply check (TX-TS)
Carburettor solenoid valve operation check (where fitted) (TC …)
Carburettor solenoid valve operation check (where fitted) (TX-TS)
Starter relay operation check (TC
Starter relay operation check TX-TS)
Electromagnetic clutch operation check ( In models with electromagnetic engagement) (TC
Electromagnetic clutch operation check ( In models with electromagnetic engagement) (TX-TS)
Electronic card operation check (TC …)
Recharge circuit check
Care and maintenance of the sealed battery
Fitting safety microswitches
Checking the operation of the bag emptying control (TX-TS)
Replacing the clock’s buffer battery (TX-TS)
Electrical diagrams (TC …)
Electrical diagrams (TX-TS)
Tightening torques and adjustments summary
Summary of main assembly amounts and checks