John Deere 595 Excavataor Technical Manual (TM1375)

TABLE OF CONTENTS

SECTION I—GENERAL INFORMATION
Group I—introduction and Safety information
Group II—General Specifications
Group Ill—Torque Values
Group IV—Fuels and Lubrication
SECTION 02—AXLES AND SUSPENSION SYSTEMS
Group 0200—Removal and Installation
Group 02iO—DifferenliaI or Bevel Drive
Group 0240—Powered Wheel Axle
Planetary Hub Reduction,
Steering Knuckle Front, and Rear Axle Housings
SECTION 03—TRANSMlSSlON
Group 0300—Removal and Installation
Group 0350—Gears, Shafts, Bearings and Power Shift Clutch
Main Shaft: Bevel Gear, Countershaft, Front Output
Shaft, 2WD-to-4WD Shifter, Low tc
High Range Shifter, Gear Pump and Front and Rear Case.
Group 0360—Hydraulic System
Propel (Transmission Drive), Motor, Brake Valve

SECTION 05—ENGlNE AUXILIARY SYSTEMS
Group 0515—Speed Controls
Engine Speed Linkage, Speed
Control Lever, Fuel Shut-Off Linkage
SECTION 09—STEERtNG SYSTEM
Group 0960—Hydraulic System Steering Valve and Steering Cylinder
SECTION IO—SERVICE BRAKES
Group 1011—Active Elements
SECTION II—PARK BRAKE
Group 1 111—Active Elements

SECTION II—PARK BRAKE—Active Elements
SECTION 16—ELECTRlCAL SYSTEMS—Batteries, Support, and Cables
Group 1671
Group 1672—Alternator, Regulator and Charging System Wiring
Group 1674—Wiring Harness and Switches
Group 1070—1nsItuments arid Indicators
Group 1677—Motors and Actuators
SECTION 18—0PERATOR’S STATION
Group 1830—Heating and Air Conditioning
Specifications—Air Conditioning