Komatsu WHEEL DOZER WD600-6R (GEN00143-03) Shop Manual

1 Block outline (for principal components only)
2 Principal component dimension table
3 Work space layout
4 General assembly schedule
5 List of equipment, jigs, tools and consumables
6 Oil, grease and paints
7 Assembly procedure
Oil and coolant
Oil and coolant capacity
Setting the front axle and bare machine to stationary position
Installing the front axle
Connecting the drive shaft
Connecting the brake pipe
Connecting the brake pipe (Brake cooling specification)
Installing tire and rim assembly
Installing step
Installing cab (1)
Installing cab (2) (AJSS specification)
Installing cab (2) (Steering wheel specification)
Installing cab (2) (AJSS and steering wheel specification)
Installinq cab (3)

Installing rear fender
Installing cab undercover
Checking of sections
Air bleeding of work equipment hydraulic circuit and respective cylinders
Starting engine (1/2)
Starting engine (2/2)
Bleeding air from brake system
Installation of H-link and Y-link
Installation of right and left support assemblies
Installation of right and left frame assemblies
Installation of blade assembly (1/2)
Installation of blade assembly (2/2)
Work equipment greasing (1 st time)
Setting machine monitor
Work equipment calibration-I, Outline and selection of service mode

GEN00143-03

SERIAL NUMBERS 60001 and up